R/C Tech Forums - View Single Post - Team Associated RC10 B5m Mid-Motor Thread
Old 04-01-2015, 06:40 AM
  #12777  
WRXnItUp
Tech Apprentice
iTrader: (4)
 
Join Date: Jun 2013
Posts: 98
Trader Rating: 4 (100%+)
Default

Originally Posted by Jimmy Avila
I was going to put a Futaba 9551 low pro servo in mine but the side where the wires come out the servo is in the way for me to screw in the blue aluminum servo holder. Is there a way I can make it fit without forcing it and pinching the servo wires???
I use the same servo in mine. I took the bottom of the servo case off and used my dremel a bit to widen the cutout where the wires come out. A new case is cheap if I decide to move the servo to another car down the road, but it keeps most of the pressure off of the wires.
WRXnItUp is offline