Originally Posted by
cnelson3
So this might seem a little overboard but has anyone measured and did the math on the angles the rear toe blocks provide? After googleing right angle trig (because it's been a while) I did the measurements and came up to 2.7* on the toe blocks without the pills. Then I did the measurements on B in/A and came to 3.2*. Technically speaking, what I thought was 3.5* is closer to 3* than the included spec sheet says. Anyone took the time to measure and calculate?
Sorry, I am to busy testing durability of the components on the car and the pipes at the track. So far, both have been holding up well.