R/C Tech Forums - View Single Post - Xray XB4 thread
Thread: Xray XB4 thread
View Single Post
Old 03-18-2015, 02:52 PM
  #7600  
rcgod
Tech Elite
iTrader: (33)
 
rcgod's Avatar
 
Join Date: Apr 2002
Location: Blackfoot Idaho.
Posts: 3,463
Trader Rating: 33 (100%+)
Default

Originally Posted by HeavyD99
Yes, the new steel 35T bevel and steel 14T pinion gears from the 2015 fit into the 2013. That's what I did. No shimming necessary so far. I built it shimmed and it was tight mesh when I ran it on the bench, it was noisy and notchy, so I removed the shims, all good.

As well your slipper sounds too tight and ya gotta let off the throttle when you land-and no jumping the tile drainage pipe that outlines the track!
Something else must be wrong. Faulty gears or mesh. The plastic 2014 gears lasted longer than that.
rcgod is offline