Originally Posted by
MaruRx7
Which of the pulleys was stripped? the 13t on the spur shaft or the diff pulley? Also did is strip all of the teeth on the belt or just one area?
I am assuming it was the 13t pulley that stripped out, and the area of the belt where the belt was on that pulley. it is likely that you had something binding up in the front drivetrain. CVD pin may have come loose as previously noted in this thread by Pickled and several others. Make sure that everything turns smoothing from the diff to the wheels, and disassemble and reassemble as necessary.
Yeah 13t for the front belt. Not sure how much of the belt was gone but it wasn't usable so i cut the belt and have been driving it around rwd mode since. Not sure how or why but everything runs smoothly.
I went around 2 shops that stock 3racing stuff (other then like pinions etc) and NO ONE has any spares. I have an order queued up with RCmart, but im not sure whether to bite the bullet and get parts, or just shelve the car for a while and get a RWD MST.