Originally Posted by
jonston
Hi Guys need some advise please this issue has me stumped.
I have a 6.2 with with various mods including
reflex racing lower shock towers
reflex lightweight arm kit
associated DJ driveshaft's
I run a front gear diff. my issue is the right hand side the driveshaft is about short about 2mm and is sticking out of the outdrive and is wobbling because its on the outer edge.
the left is fine, its inside the outdrive and spins normally.
I was running arm spacers with 2 outer dots but have change to single centre dot with the same problem. I have swapped driveshaft's from left to right with the same problem, I have changed diffs and have the same issue. I put reflex racing dcj's in and they do the same thing too. For the life of me I can not figure it out
hoping someone can point me in the right direction.
I suggest to measure from the outside of your outdrives to the bulkhead on both sides.
If it's the same, the mistake has to be somewhere around arms, hubs, axles.
If it's not the same, it should be your diff.
(I expect the bulkhead to be centerd correctly on the chassis
)