Originally Posted by
dengor
Hi everyone, just built my mbx7r eco. Went together brilliantly! Came from a Team C T8E v3, and the quality difference is very obvious. A
couple of questions though.
1. What is the set screw for on the rear uprights?
2. On the rear upright shafts, I used the spacers as per manual, but I seem to be getting a tiny bit of lateral slop there. Is this normal? If not, what's the recommended fix?
Without the SK3x3 Set Screw being installed, dirt would be allowed to enter into the upright and possibly affect the C0601 8x16 Bearings. lol
One would think it's there as a lube point possibly. Maybe someone else can chime in here and provide the real reason the hole and set screw are present.