Originally Posted by
Gordie88
There only should be a little torque on that screw ...
if your bearings are free and correct that will not spin loose.
you guys are over tighten them....
Since I had the Raceberry Conversation Kit for my TRF 417 V5, I hated the screws in the Drive Pulley and never attracted more than necessary, because I made already there my negative experience.
I had even then problems with the 2.6 mm screws, hoping for an improved system as the Smokem V7 set.
Can anyone recommend me a good screw, which can be turn out without any problems?