Originally Posted by kevinpratt823

And there again we have that curious conflict of what the inserts say they do vs. the measurements you took. If zeros have them at 2.5/3.5, a .5 on the left should only change it to 3.0/3.5, but they seem very even with that setup, which according to your measure of the right arm in that position should be 3.5 deg.........can anybody get that setup on an accurate board and get an overall toe reading?.....
The book says that zeros should be 3 deg, so going with a .5 out on the left should have it at 3.25 deg total if they are even. I haven't tried it yet but I'll have to take a look at what happens when you go with a 1 deg out on the left, though I'm guessing it throws it back off with the left having more toe.

The book does say .5 deg=.375mm, 1 deg=.75mm