Originally Posted by
bigcracing
Inline battery up against the servo with the reciever behind it next to the motor? Just wondering going to try that next but looking for some input before I cut up the plastic.
Thanks Chris
Best bet is just to try it to see if it works for you, or your set up. I cut mine apart and drilled through the bottom of the chassis, then counter sunk the holes. You can run screws into the bottom of the webbing.....into the same bosses where the battery hold down posts go, this helps make the webbing more ridged.
In any case after you do this it is still possible to re position all the electronics so you can run the battery back cross ways it you don't like it. Even with the webbing cut out.
I just switched mine back to the cross position to try it with my current set up just to see how it works.