Anybody else have trouble with the cvd pin at the axles backing out? I've been putting loctite on the grub screws but the pin works passed the screw.
Its getting more frequent. When the pin backs out, the grub screw is still tight. Seems about every 4 runs I have one back out. I'm keeping the cvd's greased. I check before each run but it still happens. I thought about putting a flat spot on the pin at the grub screw but am afraid of weakening it. May be the solution though.
When the pin backs out, ugly things happen. I have destroyed caster blocks, a swing shaft and a couple of king pin screws.