R/C Tech Forums - View Single Post - Awesomatix EP Touring Car (A700 Shaft Drive)
Thread: Awesomatix EP Touring Car (A700 Shaft Drive)
View Single Post
Old 11-21-2014, 04:20 PM
  #7431  
bkspeedo
Tech Elite
iTrader: (5)
 
bkspeedo's Avatar
 
Join Date: Nov 2007
Location: Loveeeee, CO
Posts: 3,149
Trader Rating: 5 (100%+)
Default
Originally Posted by Shock Tower
I need an advice.
I just installed new P01-P02 in left front side. After installation, my steering is not working so smooth as before.
When I disconnect the new P01/02 then the steering is smooth again. So the problem is in the P01/02.
Any surgestions about how to solve it, or shall I just leave it, and it might be more smooth after a short while. .
I have seen P02 parts that fit to tight on the ball stud. without the servo arm connected and the P01\2 combo install see if the steering blocks rotate fairly free. If not you'll need to slightly ream out the inside of P02 to free up this joint.
bkspeedo is offline  
Reply