Originally Posted by Nisstyre

Here is my stupid question for those that have built one. I started building mine on Monday, I am building the arms but the pictures are not real clear on this. the arm mounts have angled bottoms, which way are they suppose to face. the forward facing one on the manual is clear but not the rear facing. should they both be angled the same direction, will it make a difference if they are not. i think i left them slanting the same way. also if anyone gets this kit, when building the diffs, the illustration has a shim showing, i think that shim is for when you actually put the diff onto the housing, they should have added a little note on that, i spent hours trying to figure it out because it was bigger than the outdrive so no way it can be where the image shows it to be until you add it to the housing. Also i wish they would use better screws, i already stripped one of the little screws that attach the CF piece to the steering rack, just tightening it down