Originally Posted by
samnelso
People either use the Yok spring cups or they pinch the bottom spring coil. If using the Yok cups I prefer to use the Yok shock ends as well (i.e. the shock ends, the shock end balls, and a set screw into the arm instead of the stock button head) since the AE shock ends are smaller diameter than the Yok ends. Alternatively one may try putting some heat shrink around the AE end to better fit the Yok cup, although I have not tried this.
I have not seen an issue with the top of the spring, although you could pinch that coil as well.
Hey Sam, would you have a picture of what you're referring to? I'm not sure I understand the set screw in the button head thing.
That's a good idea to pinch or use shrink tube. The Exoteck lower cups seem to fit the Yoks fine, it just the upper that has me concerned.
How about a set of Yokomo shocks? Or is that too radical?