Originally Posted by
Bosscat
Hey Guys
I am running a 3.1 1s speedo on my 12th pan car running blinky software and am finding I have a small delay when starting a race, not so noticable in a stagger start qualifier but last sunday in the final I was nearly taken out by the guy who started behind me on the grid. It ok when running well at least i am not consious of a delay then.
Any ideas.
Delay usually indicates controller is running in sensorless mode. So check your sensor wire. If this is not the problem then try re-calibrating the ESC to the radio. Could also change your deadband to the lowest setting although if you are just hesitating at start then it probably a sensor issue. If the cable doesn't help then check the sensor board on the motor. I have had both go bad before and you get the delayed start feeling.