Originally Posted by
torg
It is completely different from previous version. Will have to re-run tests on all my motors.
To clarify, the timing numbers I read out are the same...
It's just the tests themselves that have changed from the old manual speed control to motor condition and current tests.
The motor current test for instance, previously I did some at 17%, 50% and 100% which will show different KV and RPM numbers. Later I got lazy and just ran them at 50%, now you can't change it. I don't know what speed % that is at... So they have given us a test where you don't know the input parameters for what is displayed on screen.
I sent a question to Motolyser asking if they could explain what this test actually does. If not I'll have to fire up IDApro on that .mot file
