Originally Posted by SLOWINSLOWOUT

I could use a bit of help with set-up. Ran my EVO w/alum chassis last weekend for the first time. I started with Mike Gee's set up, found the car very loose on power corner exit. I made some changes, got it better, but still too loose, need to wait for the car to straiten out befor I could get on the throttle, or it would try and swap ends. made getting through some right/left/right transitions very difficult. Steering is OK, a bit of under steer if anything off throttle/corner entry.

I would post my set up but this forum seems to suck at the moment to post attachments...

here is what i ended up with from Gee's set up; front unchanged exept for susp. rate 71.96(a4.0,b4.0), rear; outer shim 1.75, inner shims, 3.0, susp. rate 63.35(a4.0 b5.4), camber 2.0, toe 3.0, 3.6mm over ride drop, 1.0sway bar, diff 2000. I am also using AM06m in the rear, and AT21 no shims all around.