So with the motor shaft from 8mm to 5mm done... i got myself into more work
-Shaft 5mm done!
-Since the motor is an open motor, i use high temp silicone to seal it! Ready for 6kw of dirt raw power!
I wired a test esc to the motor to test it..
And i eared a "click" on the drivetrain. Well it is second hand.. so i know it could happen...
-Open the diffs... and find who's the guilty!
-Found... it was the front pinion gear! She a little wear out... and had a shim. I put 3 shim's on her and one more on the ring... seens good. Parts orderd already since this is gonna last just not like new!
-I open the bearings e-clip with a pin.
-I use 1:1 disc brake to clean bearings.
-Grease the bearings with teflon based grease!
-Put new silicone oil on the front diff.
Need to work now on the center one and rear one. But no click's now after the added shims!