Originally Posted by
thefan
For all those complaining about Durango's wing height being too low for the dex210, if you don't mind using an AE part then this wing mount might suit you, its off a B44 buggy at a little over $2, I only have it screwed to the tower for now and also a screw through the lower section, will maybe brace it better at the bottom eventually but its super solid as is, it took some good tumbles on the weekend and the higher wing adds some protection to the tower, not that they ever break hey!
I've never gotten around to it due to a lack of time but I was going to try one of two things. One idea is to remodel a new set of taller wing mounts/braces in 3D and have them 3D printed. Someone on Oople did this and they looked good. The other method was to just custom make a new rear tower and to use B4 or B5 wing mounts. Then just shave down the stock mounts to keep the gearbox bracing.