Originally Posted by
Raman
I have droop blocks / gauge set by dynamite
http://www.amain.com/Dynamite-Precis...-Blocks/p58986
That's what I used to measure the droop after following instructions. The arms were +5 or higher. So I adjusted then to 2 in rear and 3 in front like my other cars as a staring point.
I was just finishing and attaching dampers and noticed the that arms need to go up a bit to connect to dampers.. So my droop settings off the blocks of 3 and 2 are not sufficient. So I'm totally confused now lol.
Last.. I like the transponder idea but where is the stay? Is it not included in the kit?
I would go back to the stock droop settings and then go from there.
The transponder mount is designed to accommodate the AMB handout transponders, which have a cylinder structure that goes through the hole in the chassis and is held on by a body clip. If you check the manual, you will see exactly what I mean.
I'm using the rc4 hybrid personal transponder so I just double side tape it to the top wall of the box. Since this transponder is so small, it leaves alot of space for lead weights if you need any.