Originally Posted by
mog ruith
I bought a rtr rb6 some time back, also bought a rb5 sp for the shocks ball diff and universal. Question is after changing the dog bones for the rb5 universal the rear doesn't have or should I say have very little amount of droop. Is this the norm for you guys with the kit?
The Rb6 runs very little droop. Probably the least I've seen used on any car. Not too worry though, it works. Not sure what they did in the design, but it works and works well. Just pay close attention when you look at different setup sheets, to see which arms (either the RB6 stock or the Rb5 flat 521-1 ones), shock ends (there's three you can use, short, med, and long (the ones listed as long on the package are actually the med ones), and the length of the shock shaft (usually in the 26-28mm range between the bottom of the shock and the top of the shock end).