View Single Post
Old 06-26-2014, 11:42 AM   #3342
the incubus
Tech Elite
 
the incubus's Avatar
 
Join Date: Jan 2013
Location: South Florida
Posts: 2,974
Trader Rating: 17 (100%+)
Default

Quote:
Originally Posted by Jason Snyder View Post
So Far no.....the hole in the center of the piston is too small....I just drilled my blanks today!

I made a jig to drill pistons..If I get time tI'll try to print a bunch out...

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.
Excellent idea Jason!!!

That's precisely the type of ingenious little ideas I conjure up in my brain all the time. One suggestion though is to make the jig a tad taller on the guide side and don't go so far past the piston because the bit eats a bit of material off the jig. Just drill til it punches through and keep the power on as you pull out of the jig so as to pull any burrs with it.
__________________
ROB RIVERA
≈ PRS1 2014 :: SP Reventon Pro 1.1 :: Team Powers Plutonium17.5 ≈
≈ DEX410 :: SP Reventon Pro 1.1 :: Reedy Sonic 6.5T ≈
WWW.TRICOUNTYHOBBIES.COM :: WWW.CRPPLUS.COM
the incubus is offline   Reply With Quote