Originally Posted by
ToysRUsKid
Uriah, which bearing puller do you use for the keep-on motors? I have some older keep-ons i want to replace the rear bearing in and my Hudy puller is having a hard time with the rear bearing. I have the 18 part to put a new one in but the stock puller setup isn't working well to get it out.
I use the KM tool. It's like the hudy. You have to be careful. Find the edge of the bearing with the tool. Then expand the collet. If you stick it all the way in like normal, the collet will expand on the case, damaging it.
Make sure your installers are relieved for front, and rear bearing inner races. If they are flat, your damaging the bearings just by installing them. The inner races on some novarossi bearings stick out past the outer race. The Virtus is one of those.