Originally Posted by
13Maschine
What size droop blocks did you go with?
20mm blocks
Originally Posted by
Waflet
Hideeho
I'm still new to durango & didn't realize the desc210 came with front hexes. That's what happens when you assume things
Can you adjust the trail on the desc210 front axles the way you can on the dex210?
Follow up question about front hexes:
Could someone with a dex410 measure the offset of the front wheels? The easiest way to do it is place something straight & sturdy something (i.e. a ruler) across the back of the wheel & measure down from the top of that to the inside of the hex. Most calipers will have piece that sticks out the back as you open it, this can be used to measure depth. Then measure the width of the strait edge you measured from & subtract the from your total.
Looking at the 410 wheels, I'm betting it will be close. If these off sets are the same, people that have a 410 & a 210 will be able to run the same wheels on both (you probably don't want to run the same tires, but that is another subject
).
Not sure how accurate my calipers are but I measured it to be 23.7mm