Originally Posted by
monkeyracing
So...more than 3 new parts...chassis, arms, droop adjusters, motor plate...
Rear arm and droop screw mount is a single change as they go hand in hand. It is also molded on the same part tree as the front and rear arm.
Originally Posted by
OSherman
still only 3
Arms/DroopAdjusters is still a two-piece arm, just a different design, imo.
Only the rear arm has a separate piece to support the droop screw. You don't need to even run this piece if OAL's are still used on the rear to set the rebound stroke on the shocks.
The advantage is basically that the complete arm is a single piece.
