Originally Posted by
fredswain
I was going to use the Proline clamping hexes with the cone shaped aluminum spacer and axle shims from the B4.
so this:
http://www3.towerhobbies.com/cgi-bin...?&I=LXBVEJ&P=7
6077-00 Hexes
and these:
9608B Coned spacer
http://www3.towerhobbies.com/cgi-bin...?&I=LXEAH8&P=7
7368 Shims
http://www3.towerhobbies.com/cgi-bin...?&I=LX2976&P=7
and this will allow you to run rear 12mm hex wheels on the rear?
and to confirm, which brand to use for wheels at that point?