Originally Posted by
rossb
My kit is missing one of the 4x7mm bearings for the steering posts
When assembling the front caster blocks I noticed that the 6.2 manual says this:
The 6.1 uses the same plastic parts and the 6.1 manual says this:
I built my 6.1 putting the numbers on top for both the front and back sides. I have been running my 6.1 assembled like that for the past few years and now I think it is wrong. I never checked the caster on my setup board.
They are incorrect. You essentially have zero caster. The inserts are offset from front to rear of the c hub to create the tilt thus giving you caster angle.
The good thing is that you didn't go the other way and create positive caster.