R/C Tech Forums - View Single Post - Serpent Cobra GT-E
View Single Post
Old 04-14-2014, 03:19 PM
  #376  
scooby61
Tech Regular
iTrader: (1)
 
scooby61's Avatar
 
Join Date: May 2013
Location: Manassas Virginia
Posts: 340
Trader Rating: 1 (100%+)
Default

Ok need some help guys looking to reset my car and start all over
Long story short I built the chassis using a combo of morgantinis nitro setup and the default setup. I can't get this car handleing correctly and I'm to the point where every change I make helps one issue and worsens another.
So my setup
I run on a small track with med traction pavement and lots of tight 180 turns
16 t pinion stock spur, tekin rx8 gen 2 and tekin t8 2650
On 4s
Grp revo tires are spec for this club so I can't change those.
2.3 mm front sway bar , stock rear
35 wt shock oil with the kit stock pistons
Can't remember my ride height I think its lik 8.5rear and 7.5 frt

So the problem is I can't get ride of a horrible push without inducing a loose rear that wants to diff out
I'm 1-2 seconds off the pace of a heavier gtv2e and its really annoying
Oh also I have 300,000 front diff and center and 30,000 rear

If anyone has a setup sheet or knows where to find a good one I could use the help
scooby61 is offline