Originally Posted by
blown sv
Anyone got any info on the FT ball stud mount ?, its different height to the plastic one , can be mounted both ways with different results.
Just wondering what setting is the equivalent to the stock plastic one.
I finally broke my plastic one about a week or two ago. I thought I had kept it, but turns out I threw it away. I asked Mr. Trimmings to verify something for me yesterday in relation to the ballstud height on the aluminum piece vs plastic, as he still had both pieces.
Basically, think of it like this:
Plastic with 0 washers = 0
Aluminum with short side up = -2
Aluminum with raised side up = +2
Example: I liked my inner rear ballstud height at 0 with the plastic piece. So I need to add a 2mm washer under the ballstud with the aluminum piece short side up to remain at "0" setting.
Hope that makes sense.