Originally Posted by
xTotalghost
Anybody for a hooked up set up for indoor clay?
I'm pretty happy with mine now, and I only drive indoor clay (OCRC & LRH).
Everything is "kit" stock setup if not mentioned here:
Front End:
FLAT front arms & tower
4mm trailing
1mm under the front inner ballstud on tower
32.5 oil / 1.6 piston / AE White spring / middle shock hole on upper tower
24mm ride height
-1 camber
Rear End:
0 or 0.5 hub inserts
0 washers under inner ballstud on "tower" mount
30 oil / 1.6 piston / AE white spring / inside shock hole on upper tower
23.5mm ride height
-1 to -1.5 camber
Standard hub insert position for outer ballstud link
I prefer the car with saddles vs shorty so far. Batteries all the way pushed back.
Good luck