First time RB6 build
Build went pretty good. I'm impressed with the quality and tolerances of parts. Can't wait to hit the track this weekend.
Need help with a couple of things.
After re-reading the manual after my build I noticed that I MAY not have set the rounded edge of the differential plates facing the balls. I did sand the diff plates as I always do with every diff build. If the rounded edge of the plates aren't facing each other will this degrade performance in any way?
The upper plastic ball / eyelets for the shock caps have a fair bit of slop in them. Is this normal? Bottom ones seem fine and fits well.
In MM Mid-motor configuration the bottom of the rear shocks only mount to 1 hole location. Shouldn't there be more locations? Are my arms backwards?