Originally Posted by
Shock Tower
I am new to xray, and is just in the process to build a brand new T4 14. Came to the point today, where i was putting the rear uprights on the rear suspension arms. All that went fine, but when i mounted the upper turn buckles, the the hole suspension was binding ?
I have made the tunbuckles to the specific lenght for the rear on 52.8mm from end to end, but it just was to short. I also checked that I have screw in the right holes, and I used the inner hole on the uprights, and the outer hole on the upper clamps.
Any surgestion of what might have been wrong ?
Have you put the correct driveshafts in the rear? they are shorter at the back