Originally Posted by
qZOMBIEXTUNAp
I am running the CF ackerman arm with the Alum bell cranks and it just flops around. No side to side play, but floppy up and down. Seems ok in the truck. Is this normal? truck is an SC10....
Make sure you CA the outside and inside (bearing holes). Just wet a cue tip with medium JC glue and seal the CF edges with the cue tip. After it dries, you'll have to press the bearings into the carbon and it will be slop free.
When will hobby shops have the b5 body's
They started shipping late last week; depends on when your shop ordered them.
I have decided to try jc tires this. Know my question is what are the tires to carry for out door tracks from lose to medium grip. I have a set of doudble d for my sct. One set of black jacket for my buggy. And one set of double d for truggy. So far. I think I need a tire like the city block and maybe a set of sevens.can I get a little infor or help on what I might be missing.
Sounds like you are running SCT & 1/8th (buggy/Truggy).
Outdoor non-blue groove lose conditions:
SCT = 3D's & DD's
1/8 Buggy = Sub Cultures & Hybrids
1/8th Truggy = Sub Cultures & Hybrids
Hard pack grooved med/high bite conditions:
SCT = DD's & Bar Codes
1/8 Buggy = Hybrids & Stackers
1/8 Truggy = Hybrids & Stackers