Front:
1.565" gray, 1/4" SXT inside
.45mm front springs, .5mm droop
5* blocks, 2 shims forward and 1 back
graphite high roll center, thicker ones.
barely 3/4* camber
1-.015" shim on axles (didn't try to widen front)
barely 3mm ride height at nose of chassis
Rear:
1.64" gray, full SXT
20k in 1 tube, 30k in other
35wt. center shock with new red spring
new .50mm taperd side springs, just touching
2mm droop
3.25mm ride height
Other info:
Power Push white lightening battery positioned forward
Team Scream (D3.5) motor, HT 12.5 rotor
CRC body (Mohawk)
SXT set just 5 minutes
Hobbywing 1s esc
SG1 - thanks for the ideas for the front suspension here. I put this on my regular XTi (battery transverse and forward). Used the 2.0mm roll center shim instead of the 2.5mm. Used 30K dampening instead of 50. I liked the .45 springs on this and didn't have trouble with the outside front dipping too much. Car was very solid after moving battery forward. Seems much better than the stock setup from the kit. Appears it will do well on heavy traction as well as the light traction we have at our track. And it did well on the 180's we had.