Originally Posted by
Shock Tower
Just discovered that one of my rear wishbones precision balls have fairly amount of sloop when the shocks are dismounted.
Is there any fix to get rid of this kind of sloop ?
Originally Posted by
haywood
If I'm thinking correctly I think you can replace them if you can get them out. I would try to hang the arm in a can of acetone to try to loosen the glue. I'm sure Phil could tell us if this would work?
Other option is to pop the ball out, and then run a thin film of ca glue around the inside. Let it dry and then put the ball back in. Might be a little tight to begin with, but this can tighten up the pivot balls nicely.