Originally Posted by
sgp-chris
Well that explains ALOT! Thank you, I will try that when I get home. I uset the RX cable because it was show in the program box manual...
I am hoping that a firmware upgrade is the solution...
My current firmware is V3.1_121129_Beta
Is that okay, or should I upgrade to something else???
EDIT: Next piece to the puzzle. I've again tried 2 different SP motors, and 3 sensor wires. When I give it full throttle and let go again, the motor will only stop working when it stops at a certain point. I watched the set screw on the pinion, and it would only refuse to rev again when it stopped at the exact same angle of rotation. I switched motor, and it was the same result with both. But the rotation angle was different between the motors.
If it stopped at any otner point of rotation, I could rev it again with no issues.
Does this mean I have a sensor problem inside the esc? Changing wires didn't help the issue.
It also sounds abit rough when it runs. Not like when it runs completely withpout a sensor, but something in between. It's not a nice smooth sound. It goes for both motors.