Also, my kit didn't come with 5k/5k/3k....only 5k for all diffs. I guess I'll give the standard setup a try first and make changes accordingly if people like 3k in the rear.
I don't know what people are complaining about on fit when assembling? Everything has been great so far. The only thing close to being tight was installing the assembled front end on the chassis where the hing pin brace fits on the chassis. Even the ball joints have been smooth. The upper 5mm rod ends were a hair tight but nothing preventing smooth operation. Am I missing something? Also, the front center dog bone is a little warped but I'm sure it'll straighten out with some high RPM run time...
On to the rear next...
