Originally Posted by
sanny632
Sweet. Hey Casper I put the tlr3100 in w two shims on each side. Good place to start? It's smooth on ring and pinion.
Should be ok. You want the rear shimmed a little on the tight side but not to the point of binding
Originally Posted by
skyler hays
On the setup sheet. What are witness marks? That puzzles me.
Thanks
Yeah the wheel may mark the arm and or the steering link depending on your toe settings
Originally Posted by
JKoiva
Right , so I put a .5mm clutch shim in, there is just not enough room. it binds up and won't spin freely by hand....
Your bearings may not be fully seated or tolerance stack up on your parts. Take .1 out. Either that or get a set of the new +.5 hexes.