Originally Posted by
CraigMBA
This is probably my last post here. I had a great time with my Cyclones, but since I seem to be Mr. All Things Tamiya these days, it's time to turn the page. I'm posting because I haven't built a new VTA car yet, and I wanted to post that I'd had success putting TCX gear diffs in with only two part numbers necessary to complete the task. Here they are installed:
I used the 2mm shims (one on each side). Here are the PNs you need to convert over. ICRC, total cost was like $32.
Good luck guys!
Did you put a gear diff in the rear too? BTW what weight diff oils did you use? I found both PNs on A Main