Hi guys and girls. I have a Reventon Pro that's done about three meetings in 1/10 TC (13.5T, stock 1 setting) Today I changed some settings and put the boost to 150k as per some guys setup sheets. I went to full throttle and it cut out. Now when you push the button to turn it on, it comes on, but as soon as you release the button it turns off. It didn't over heat or do anything silly neither did the motor. It will still connect to the computer so I reset everything back to default then reset it all again but the same thing happens, push the button down and it fires up, release the button and it turns off. Any Ideas ???