Originally Posted by
JimmyMack12
With running these Touring cars (and not sure if it's just this one, or most all TC's), do you *always* have to take off the top deck just to change a pinion? or, is it safe to cut a notch just above the pinion to get to the set screw?
No, turn the car upside down, loosen off the grub screw through the big oval cutout in the bottom of the chassis and then slide the pinion out. This will only work upto about 35 or 36T pinions anything bigger and well you have to remove 1/2 the top deck screws to get enough room to remove the pinion.