Originally Posted by
Speedychris22
What is the purpose of the rear skid angle? I see most use .5 shim but I did see one setup that used the 1mm shim.
If you are talking about the section for the manual:
They show that if you take the shim out in between the tower and the mount, that you are running more anti-squat. You will get a lot more side bite with the shim in there.
For MM you have to run a total of 1mm with the shims for the tower to remain at the correct height and angle.
1mm between the holder and bumper = 0 between tower and holder
.5mm is .5mm between tower and holder
0mm is 1mm between tower and holer
For RM you just run the shim between the holder and bumper since the tower height is unaffected with the adjustment.