Originally Posted by
Randy_Pike
Hey, I'm i bit confused.
C1 and C2 are both custom. You can adjust the settings and "save" each by hitting "apply settings." Then if you wish to swap between them, simply select the profile you want, and hit "apply settings" OR you can use the onboard button interface to swap between profile 6(C1) or 7(C2) via the led tree.
Does that help?
Thanks for the quick reply.
I hope this helps when I switch on the dual mode in C1 or in C2 then i do the apply button it is in dual mode.
When i wont to switch off the dual mode to sensored only it will not switch off.
And I mean in both customer modes C1 or C2 it stays in dual mode.
Strange?
And again thanks for trying to understand my problem.
For the moment I have loaded the 212 software and everything is fine except
that I have no blinky mode for other classes.
Thanks