R/C Tech Forums - View Single Post - T.O.P Racing's Rebel 1/12th scale
Thread: T.O.P Racing's Rebel 1/12th scale
View Single Post
Old 01-03-2014, 01:34 PM
  #1148  
L.Fairtrace
Tech Elite
iTrader: (24)
 
L.Fairtrace's Avatar
 
Join Date: Apr 2004
Location: Beyond the Wall
Posts: 3,808
Trader Rating: 24 (100%+)
Default
Originally Posted by Outlaw 44
Hi all!

Just finished rebuilding a used Top Rebel 12 that I recently purchased. The front end is killer! I can't wait to put it on the track.

However while rebuilding I noticed that the LR hub is bent.

I was thinking about ordering a set of rear hubs from CRC so that I could run the bigger american-sized screws to tie down the rear wheels. Has anyone tried this, and will they fit on the Rebel 12?
you must have the V1 hub on the left side. That hub was designed wrong and when you tightened it down it bent/twisted some.

Get the V2 hub from Top USA or wherever you are and get some 2.5mm x 8mm cap head screws from Mcmaster and life will be good.
L.Fairtrace is offline  
Reply