Originally Posted by
The Teacher
TryHard, who makes the center ball steering rack and 1mm in ackerman plates that you run???
I made them myself. The ackerman plates, I just cut up a buggered chassis plate that I had from a previous car, and drew up in cad a template to mark out the new hole positions.
The rack, was also pretty simple. Firstly filled in the cut-out in the rack, by cutting a strip of carbon to size, and sanding it down to the right thickness, before Aralditing it in place. Then I drilled and tapped new holes in the middle of the rack, 8mm apart.
HiH
Ed