View Single Post
Old 12-11-2013, 09:59 AM   #9846
rc car guy
Tech Addict
 
rc car guy's Avatar
 
Join Date: Sep 2013
Posts: 647
Default

Quote:
Originally Posted by Dan Hamann View Post
12.5 rotor. Aluminum screws is something up to the individual. I've had them , never had issues. Some guys I know have had nothing but issues with aluminum. Probably wise to run Ti or Steel through high stress areas to prevent busting off screws, especially if the car sees a lot of impacts.
ya i currenty only have them in the plastic portions

cut like 10grams out of the car just by that so far
rc car guy is offline   Reply With Quote