Originally Posted by
xragex
Hey,
got mine last week and start building yesterday. Car is really nice to build, but got some problems with the lower suspension arms.
Main problem, when i measure from the top of the lower suspension arm on the left side to the ground, it is about 14mm, but if i measure on the right side it's only 12,5mm.
I think the problem appears because they're using one lower arm for both sides?!
Anyone got the same problem?
Thanks
I see that Joey already responded to you and recommended using AE lower arms, which I would also recommend. Please be sure to use the v2 lower arms from AE, and you will also need the AE lower pivot balls.
At the same time, please send an email to
[email protected] describing what you are seeing and she will help you get replacement parts. You can also try sanding down the VBC arms, but it is likely easier to just use AE for now and talk to Annie about getting replacements.