Originally Posted by
theproffesor
I did notice that on one of the pins, but that issue was corrected before the pic was taken. I am going to continue the build up of the car and maybe it will become a none issue as the suspension come fully together.
The whole is greater than the sum of its parts.
And thanks for the heads up on the ball cup. Didnt even notice the difference. Ill have to go through the suspension and check all of them to put them in the correct spot.
I just checked my droop settings too, and it looks like yours. Use the base setup from
http://www.petitrc.com/reglages/vbcr...tBaseSetup.pdf
You still have about 2mm of wiggle room for droop. besides, too much front droop will cause the car to be unstable and do a sudden hook.
As far as the suspension blocks go, I wouldn't worry too much. Just make sure that your arms are not binding in anyway and you should be good.
Just build the car and run it. You won't be disappointed
