R/C Tech Forums - View Single Post - Kyosho Ultima RB6 & RB6.6 Car Thread
Thread: Kyosho Ultima RB6 & RB6.6 Car Thread
View Single Post
Old 11-19-2013, 03:23 PM
  #8704  
ovalracer1m
Tech Master
iTrader: (29)
 
ovalracer1m's Avatar
 
Join Date: May 2006
Location: Alexandria, MN
Posts: 1,173
Trader Rating: 29 (100%+)
Default
Originally Posted by Jochim_18
I measure the height of the hinge pin from the chassis when I shim the rear 2mm it gave me an equal measurement front to rear of the hinge pin giving you 0 degree anti-squat..

I have been fine tuning my TC and the degree of the squat is = to the thickness of the shims..
good to know from someone that has actually measured it. So on your MM setup, you are raising the rear block 2.5mm and also raising the rear bulkhead tower 1mm with the skid shim? So how much spacers are you using between the transcase and the chassis to equal out the height of the assembly?
ovalracer1m is offline  
Reply