Originally Posted by
Blown up
Anyone try to bolt a tekin Gen2 6.5 to this motor mount? The tekin I have doesn't line up w/the screw holes in the motor mount... The gen2 srcew holes are a smidge wider than the xb4 mount holes. I ended up bolting an LRP X12 7.5 in no problem. Tons of room in this rig compared to other wheelers I've had, wiring came out slick. I need to pop off the top deck to route a new sensor wire and I'll take a pic.
I run the Gen 2 6.5. It will work. The trick is to get one screw started just a hair. Then get the next screw started..... and then tighten them both.... in alternating increments. You have to be smarter than the screws.
Don't mind the big hole where an ESC should be. Tekin has supply issues... which is nothing new. No pun intended.