Originally Posted by
hitcharide1
While I'm at it, we think we have an idea how to finally get all the flex we want, without using "articulated" anything. We'll have the prototype chassis mocked up sometime next week and bench test it. Sort of like a "t" chassis in the rear but still with a solid chassis, it wouldn't work with any other build but should do nicely with this one.
It sounds like you are going the same route as I am. Use a flexible chassis, put the motor pod somewhere near the center, drive the rear end with a drive shaft and U/CV joints.
Next step, decide where to hang the dampers! I was planning on using one per corner.
You do realize that if you keep this up, I'll have no reason to continue on mine, right?
I can't wait to see the photos!